1999 ACURA CL 2DR COUPE
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/WHT (-) AT FACTORY SECURITY UNDER PASS SEAT
TrunkTrigger LT.GRN/BLK - (-) UNDER PASS.SEAT (ORG AT TRUNK LIGHT)
FactoryAlarmDisarm BLU AT FACTORY SECURITY UNDER PASS SEAT
ParkingLights RED/BLK + (+) LEFT OF COLUMN OR AT SECURITY MODULE
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 WHT/BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
KeySense BLU/WHT - (-) IGNITION SWITCH HARNESS
NeutralSafety GRN/WHT - (-) AT GEAR SELECT SWITCH
Tach BLU - (AC) DIST PACK NEAR SHOCK TOWER PASS SIDE
ParkingLights RED/BLK + (+) LEFT OF COLUMN OR AT SECURITY MODULE
BrakeLights GRN/WHT + (+) AT BRAKE SWITCH
ReverseLights GRN/BLK + (+) AT GEAR SELECT SWITCH
Horn LT GRN/BLU - 20 PIN BLU CONNECTOR BEHIND DRIVER DASH
Doorlocks / Window
PowerUnLock RED/BLU - (-) AT FACTORY SECURITY UNDER PASS SEAT
PowerLock RED/YEL - (-) AT FACTORY SECURITY UNDER PASS SEAT
Convenience
HeadLights RED/YEL + (+) 14 PIN BRN CONN.IN DRIVER KICK
TrunkRelease BLU/RED + (+) AT FACTORY SECURITY UNDER PASS SEAT
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination RED/BLK + (+) RADIO HARNESS
AMPTurnOn YELLOW/WHITE (+) RADIO HARNESS
FrontLeftSpeakerPos WHT
FrontLeftSpeakerNeg BLK
FrontRightSpeakerPos BLU
FrontRightSpeakerNeg BROWN
RearLeftSpeakerPos ORG
RearLeftSpeakerNeg GRN
RearRightSpeakerPos YEL
RearRightSpeakerNeg RED
Amp RT REAR OF TRUNK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
